Unify OpenScape Cordless IP V2 Service Documentation

c07.fm
Diagnosis and Maintenance
Testing the Radio Area
A31003-C1020-S100-03-7620, 12/2017
OpenScape Cordless IP V2, Service Documentation 89
The measurement values are displayed when the mobile telephone is switched
on. Measurements are performed at the set intervals (see Section 7.2.1).
Activate the measuring mode:
Using the navigation key,
scroll down to "Measuring
time".
Confirm with OK.
Measuring mode is switched
on; this is indicated by the
tick next to "Measuring
mode".
Select the measuring time:
Using the navigation key,
scroll down to "Measuring
time".
Confirm with OK.
Set the value range:
Press the navigation key:
to increase the value range
Press the navigation key:
to reduce the value range
Value range: 06 to 16
Recommended value range:
16
(measuring cycle: 1 s to 2.5
s)
Press the Save key
to confirm the value range
set
Switch off the mobile telephone:
Press the on-hook key until
the confirmation beep is
heard (ascending tone
sequence).
Nothing is displayed
OK
Service
Measuring mode
DSP parameters
Measuring time
Service 6
OK
OK
Service
Measuring time
Measuring mode
Service 7
OK
LLLLLLLLLLLLL
Service
Measuring time
Measuring time
Save
<16>
Save

Unify OpenScape Cordless IP V2 Specifications

General

Brand	Unify
Model	OpenScape Cordless IP V2
Category	Accessories
Language	English