P31003C1020M1000276A9, 01/2018
OpenScape Cordless IP V2, Administrator Documentation 37
Base stations
Base station synchronisation
6.2.2 List of synchronised base stations
All activated base stations contained in the Connected base stations list ( p. 27) appear in the Base station
synchronization list.
Settings Base stations Synchronization
For each registered base station the following information is shown:
6.2.3 Actions
Setting up the base station synchronisation
Select the cluster to which the base should be assigned to from the Cluster option menu.
Base stations only synchronise within the same cluster, meaning that a handover of a handset from one cluster
to a neighbouring cluster is not possible. The DECT multicell system can manage up to nine clusters.
Select the synchronisation level for the base station from the DECT Level option menu.
MAC address Hardware address of the base station. With this address the device is uniquely identified
within the LAN.
Base station Name of the base station.
DECT manager Name of DECT manager the base station belongs to.
Currently always local: The base station belongs to the configuring device.
Cluster Number of the cluster to which the base is assigned.
DECT Level Synchronisation level within the sync hierarchy.
LAN Master The base station acting as LAN master is marked by a .
Sync Slave Indicates if the base station is synchronised via DECT or via LAN. For the Sync master
there is no entry in this column.
Status Synchronisation status of the base station:
0 Offline Not available
1 Deactivated Available but not activated
2 No sync Activated but not synchronised
3 Sync Activated and synchronised
4 Sync Overload Synchronised but DECT overload
To Next Page
Loading...
Need help?
General