P31003C1020M1000276A9, 01/2018
84 OpenScape Cordless IP V2, Administrator Documentation
System settings
Save and restore
11.8 Save and restore
This page allows you to save and restore the system configuration.
Settings System Save and restore
Once you have configured the DECT manager and after making any changes to the configuration, particularly reg-
istering or de-registering handsets, you should save the latest settings in a file on the computer so that the current
system can be restored quickly if problems occur.
If you change the settings accidentally or you need to reset the DECT manager due to a fault, you can reload the
saved settings from the file on your computer to your telephone system.
The configuration file contains all system data including the DECT registration data of the handsets, but not the
calls list on the handsets.
Saving configuration data
Click on Save settings Select the location where the configuration file should be stored using the system file
selection dialogue. Enter a name for the configuration file.
Restoring configuration data
Click on Browse... Select the previously saved configuration file from the file system of your computer.
Click on Upload . . . the selected configuration file is loaded.
The secure configuration file can also be loaded onto a new device.
Prerequisites:
• The old device must no longer be in operation.
• The firmware version of the new device must correspond, at least, with the version of the device
from which the data is saved, including the set patches.
To Next Page
Loading...
Need help?
General