Uninet DTF 1000 User Manual

pg. 16 UNINET DTF 1000
may turn the printer back on using the blue switch, the print head will move back to its
home location on its own.
LOADING FILM
With the film roll securly seated in the roll feeder, place the roll feeder behind the printer
approximately six inches away. The print side of the media is the matte side not the glossy side.
To load the film into the printer follow these steps:
1. Cut approximately eight inches of the film off the roll that is on the feeder.
2. Using the cut media, gently place under the rollers that line the printing platform on the
printer.
3. Using the top green button located on the lefthand side of the printer, feed the cut media
backwards until you can see it sticking out of the rear of the printer.
4. Once you can see the cut media sticking out the back of the printer, take the film on the roll
(matte side up) and place it under the silver bar that can be seen from the back of the
printer and over the cut media.
5. Using the bottom green button on the lefthand side of the printer, feed the film and cut
media forward until you can remove the cut piece.
6. Using the two green buttons that control the rollers, adjust your film so that it is aligned
with the last row of holes on the righthand side of the printing platform.
Film feeding into the back of printer

Uninet DTF 1000 Specifications

General

Brand	Uninet
Model	DTF 1000
Category	Printer
Language	English