pg. 28 UNINET DTF 1000
TROUBLESHOOTING
Problem: Prints are clear on one side but blurry on the other side, also applies to same problem
front to back.
Solution: The UNINET™ printer has to be on a level surface to print correctly across the whole
surface of the film.
Problem: Printed images have bands or lines in it.
Solution: Perform a nozzle check to verify all the nozzles are printing. If some are not printing
perform head cleaning or increase the resolution of the image that needs printing.
Recommended settings are 1440x1440 dpi.
Problem: Prints appear split and blurry.
Solution: It could happen during printing on media with an irregular surface. Disable “High
Speed” in Advanced tab on printer driver.
P
roblem: All lights are off.
Solut
ion: Press the button to make sure the printer is on. Turn on the printer and make sure
that the power cord is securely plugged in. Make sure that your outlet works and is not
controlled by a wall switch or timer.
Problem: Ink light and Paper light flash simultaneously.
Solution: Check on the status monitor in the WIC program. If the screen says that some parts
inside your printer need to be serviced, then you need to reset the waste pads.
TECHNICAL SUPPORT
You should always contact an authorized dealer of UNINET™ for assistance or for any technical
To Next Page
Loading...
