pg. 18 UNINET DTF 1000
Lastly, a Windows Security window will appear. Select “Install”.
*In the event Epson asks to perform an update, decline or cancel it as it could result in
compatibility issues with the printer and/or software.
Once all the steps seen above have been completed, you may start using your printer.
DO NOT STOP PRINTER
If you have an image that is already printing but need to stop it in the middle of the job,
it is not recommended to disrupt the printing process. It is recommended to let the print
job complete if the image or job is small. Stopping or canceling a print job before it is
complete will cause the printer to present an error which can be cleared by powering the
printing module off then back on using the red button on the right-hand side. If the
printing module is power cycled, the media roll will feed about 2 meters then present a
paper error which can be cleared by holding the blue button for 3-5 seconds. After
clearing both errors, so long as the media is clean, be sure to rewind your media roll neatly
so that the alignment is maintained.
If you choose to cancel a print and stop the printer, follow these steps:
1)
Power the printing module off using the red button.
2)
Delete any jobs in the software and printer’s queue.
3)
Power the printing module back up with the red button.
4)
Clear paper error by holding the blue button.
5)
Rewind and realign the unused media.
EMERGENCY STOP
If it is absolutely necessary that the printer needs to halt right where it is, the main power to
the entire unit can be turn off by flipping the large blue switch on the right-hand side of the
front on the unit.
To Next Page
Loading...
Need help?
General
