Unipulse F340A - Numerical Display; Setting Key Pad

1.FUNCTIONAL DESCRIPTIONS
2
1-1-2. Numerical Display
The three types of display are provided.
1）Indicated value
2）Set value
3）Overflow display
• Minus overflow of the A/D converter （－ LOAD）
• Plus overflow of the A/D converter （LOAD）
• Indicated value overflowed （indicated value ＜－ 19999）（OFL1）
• Indicated value overflowed （indicated value ＞ 19999）（OFL2）
1-1-3. Setting Key Pad
These are keys for commanding settings and operations.
Increments by one the numeric in the blinking digit of the setting
item selection or set value.
Decrements by one the numeric in the blinking digit of the setting
item selection or set value.
Enters the setting mode. Setting mode“F1” is indicated.
This key sets a decimal point in the span calibration.
Enters the actual load calibration mode.
Select the setting mode number and the blinking digit of the setting
value in setting.
Enters the equivalent input calibration mode.
Inputs the minus sign in setting.
UP
DOWN
FNC
SEL
SHIFT
CAL
FNC
Indicated value display Setting mode“F1”
display