Need help?Do you have a question about the Unipulse F381A and is the answer not in the manual?
General| Resolution | 320 x 240 pixels |
|---|---|
| Touch Type | Resistive |
| Interface | RS-232C |
| Operating Temperature | 0 to 50 degree C |
| Storage Temperature | -20°C to 60°C |
| Power Supply | 24V DC |
Essential safety guidelines for using the F381A, including warnings and cautions.
Precautions for safely installing the F381A unit.
Guidelines for safe and correct wiring of the F381A.
Safety procedures during the initial startup and maintenance of the F381A.
Guidelines for proper installation of the F381A in various environments.
Precautions for wiring the signal input/output terminals correctly.
Safety measures during startup and maintenance procedures.
Details on setting conditions for starting and stopping measurements.
Procedure for installing the F381A into a control panel.
Instructions for connecting various sensors, including analog and displacement types.
Connecting external control equipment and understanding input/output circuits.
Releasing parameter protection and calibrating the Y-axis (load sensor).
Calibrating and setting the X-axis (displacement sensor) including time/displacement modes.
Configuring hold functions, including types, sections, and detection parameters.
Setting up and performing waveform comparison with reference waveforms and areas.
Details on commands for reading/writing set values, calibration, and waveforms.
List and descriptions of F381A error messages.
Common questions and answers for troubleshooting F381A issues.
To Next Page
