Unipulse F381A - Display Read Command

100
5 COMMUNICATIONS
100
COMMUNICATIONS
Chapter
5
- Display read command
F381A’s return
(In normal processing)
0000 ， 51 ， 0 ， 0 Delimiter
（ STX ） 13R+ ， A0 . 00 ，
-: Without judgment 3: LO
1: OK 4: H/L
2: HI 5: NG
Load result
Load data
-9999 to +9999
(with a decimal point)
Command received by the F381A
Header (If there is no header, no data will result.)
Displacement: -9999 to +32000
Time: - - - - -
Load error status
*1
Displacement result
-: X-axis; time 3: LO
1: OK 4: H/L
2: HI 5: NG
Work No.
Measurement status
0: Wait St. 4: Wait Cal.
1: Wait Off 5: Complete
2: Wait Lv. 6: Reset On
3: Sampling
Displacement
error status
*2
5100 20 ， 01. ， +000
000000
Host
(Transmission to the F381A)
RA Delimiter
Comp. error
0: None 1: Comp. error
*1 *2 ( －－－－ for time)
Zero Limit
0: None 1: Zero Limit
Overload
0: None 1: Overload
Over
0: None 1: +Over 2: -Over
Sensor error
0: None 1: Sensor +error 2: Sensor -error
Calibration error
0: None 1: Zero error 2: Span error
Pace error
0: None 1: Pace error
Over
0: None 1: +Over 2: -Over
Sensor error
0: None 1: Sensor +error 2: Sensor -error
Calibration error
0: None 1: Zero error 2: Span error
0000
（ STX ） Delimiter N1G
F381A’s return
(In abnormal condition)
Header (If there is no header, no data will result.)
NG No.
1: Receipt of a statement different from the command format
(with a decimal point)