17
2 INSTALLATION AND CONNECTION
17
INSTALLATION AND CONNECTION
Chapter
2
■Connector pin assignments
* Input COM and Input COM, Output COM and Output COM are internally connected.
* Input COM and Output COM are internally isolated.
* Input COM and F.G., Output COM and F.G. are connected with the capacitor.
[1] There is a judgment (NG judgment) which all of the judgment outputs LO, OK and HI are not
set to on.Please fetch the outputs in synchronization with the Complete output is changed from
OFF→ON.（See Page 21 "- Input signal timing check" ）
[2] Please confirm turning OFF and ON(OFF→ON) of the Complete output at every
measurement to confirm the measurement has been updated.
A1 IN Load Digital Zero B1 IN Work 1
A2 IN DPM Positioning B2 IN Work 2
A3 IN Start B3 IN Work 4
A4 IN Stop B4 IN Work 8
A5 IN Hold B5 IN N.C
A6 IN Reset B6 IN N.C
A7 IN Backlight On B7 IN N.C
A8 IN Prohibit Touch Panel B8 IN N.C
A9 IN
COM
(Input)
Plus common connection: +24V
Minus common connection: 0V
B9 IN
COM
(Input)
Plus common connection: +24V
Minus common connection: 0V
A10 IN
COM
(Input)
Plus common connection: +24V
Minus common connection: 0V
B10 IN
COM
(Input)
Plus common connection: +24V
Minus common connection: 0V
A11 OUT
COM
(Output)
Sink type (Standard): 0V
Source type (ISC): +24V
B11 OUT
COM
(Output)
Sink type (Standard): 0V
Source type (ISC): +24V
A12 OUT
COM
(Output)
Sink type (Standard): 0V
Source type (ISC): +24V
B12 OUT
COM
(Output)
Sink type (Standard): 0V
Source type (ISC): +24V
A13 OUT
Hold
Result
Load
LO
[1]
B13 OUT
Wave Result
LO
[1]
A14 OUT OK
[1]
B14 OUT OK
[1]
A15 OUT HI
[1]
B15 OUT HI
[1]
A16 OUT
DPM
LO
[1]
B16 OUT Complete
[1][2]
A17 OUT OK
[1]
B17 OUT Run
A18 OUT HI
[1]
B18 OUT Load OK
A19 OUT Overload B19 OUT DPM OK
A20 OUT N.C B20 OUT SD OK
Connect elements that can pass Ic=5mA or more.
The leak current of the elements connected should be 400μA or less.
Attention
The adaptable connector
Connector: FCN-361J040-AU (attachments)
Cover: FCN-360C040-B (attachments)
To Next Page
Loading...
