Unipulse F381A - Waveform Update Check;Equipment ID Read Command

94
5 COMMUNICATIONS
94
COMMUNICATIONS
Chapter
5
② Read the measurement results.
- Waveform update check/equipment ID read command
Host
(Transmission to the F381A)
UTLRES Delimiter
（ STX ） Delimiter N1G
F381A’s return
(In abnormal condition)
Header (If there is no header, no data will result.)
NG No.
1: Receipt of a statement different from the command format
F381A’s return
(In normal processing)
Command received
Load result
-: Section not in use
1: OK
2: HI
3: LO
4: H/L
5: NG
Displacement result
41 ， 3233 ， Delimiter
-: Section not in use
or X-axis; time
1: OK
2: HI
3: LO
4: H/L
5: NG
（ STX ） 1LRS ， EUT 443 ， 13 ，， 24
Total result Section1
by the F381A Judgment
Section2
Judgment
Section3
Judgment
Header (If there is no header, no data will result.)
Section4
Judgment
Section5
Judgment
Waveform
Comparison
Load Load Load Load
Load Load Load
Judgment
Displacement Displacement Displacement Displacement
Displacement Displacement Displacement
Host
(Transmission to the F381A)
PELSAM Delimiter
F381A’s return
(In normal processing)
（ STX ） Delimiter 0LSM 3APE11
Undefined
Work No. used for measurement
Header (If there is no header, no data will result.)
Waveform update
0: Not made
1: Made
(If an update is made, this bit changes
from 0 to 1 only once upon reading.)
518
Equipment ID
* Equipment ID is a parameter.
(It can be set from the touch panel only
when the SD card slot option/Ethernet option
is mounted.)
（ STX ） Delimiter N1G
F381A’s return
(In abnormal condition)
Header (If there is no header, no data will result.)
NG No.
1: Receipt of a statement different from the command format