Unipulse F381A - Communication Commands

87
5 COMMUNICATIONS
87
COMMUNICATIONS
Chapter
5
- Set value read command (First Setting)
Example: Reading Excitation Voltage, Y-axis Setting, First Setting
- Set value read command (Work Setting)
Example: Reading Y-axis Start Point, Display Range Setting, Work No. 10, Work Setting
① Writing “10” to Work No.
R100 Delimiter 0
Host
(Transmission to the F381A)
Item No. (See the list of set value commands.)
Excitation Voltage in the example
Item group (See the list of set value commands.)
Y-axis Setting in the example
（ STX ） Delimiter N1G
F381A’s return
(In normal processing)
F381A’s return
(In abnormal condition)
Data of the specified set value
Command received by the F381A
Header (If there is no header, no data will result.)
Header (If there is no header, no data will result.)
（ STX ） Delimiter 00R1 000+00 010
NG No.
1: Receipt of a statement different from the command format
Host
(Transmission to the F381A)
Item No. (See the list of set value commands.)
Work No. in the example
Item group (See the list of set value commands.)
Work Setting in the example
00+0000010W1 0 Delimiter
Data to write
The amount of data varies depending on the set value.
F381A’s return
(In normal processing)
Command received by the F381A
Header (If there is no header, no data will result.)
（ STX ） Delimiter 00W0 010+00 001
（ STX ） Delimiter N1G
F381A’s return
(In abnormal condition)
Header (If there is no header, no data will result.)
NG No.
1: Receipt of a statement different from the command format
2: Attempt to write a set value outside the setting range
4: Attempt to write a set value through communications
during measurement
5: Attempt to write while protecting