Unipulse F381A - 4 SETTINGS AND CALIBRATIONS; Parameter Protection and Y-axis Settings

39
4 SETTINGS AND CALIBRATIONS
39
SETTINGS AND CALIBRATIONS
Chapter
4
4-1. Release of parameter protection
To change set values, release their respective locks.
Release of Work Setting Parameter Protection
Operation
Main screen→Setting→First Setting→System Setting→Work Protect→Not Protect
Release of First Setting Parameter Protection
Operation
Main screen→Setting→First Setting→System Setting→First Protect→Not Protect
4-2. Y-axis setting
Calibrate and set the load sensor by Y-axis Setting. Set each item according to the setting order.
Operation
Main screen→Setting→ First Setting→Y-axis Setting (→Next→Next)
4 SETTINGS AND CALIBRATIONS