119
5 COMMUNICATIONS
119
COMMUNICATIONS
Chapter
5
■Communication method
(when the Communication Mode is Hold Point Mode)
After completion of measurement, the Hold Result of each section is automatically transmitted to the host.
Example: When the hold function is used in Section 1 to 3 of a measurement waveform
* The format of section data is the same as that for reading hold results.
■Cautions
- Work No. for RS-232C communications
Once Work No. is written, it will be reflected afterward throughout reading and writing of settings
by work. This work No. is just for RS-232C communications. The F381A’s work is not changed.
Also, the Work No. display in Work Setting is not changed.
- About Section No. for RS-232C communications
Once Section No. is written (with the currently-specified Work No.), it will be reflected afterward
throughout reading and writing of hold settings. This section No. is just for RS-232C
communications. The F381A’s section is not changed. Also, the Section display in Hold Setting is
not changed.
- About communications during measurement
During measurement, writing or calibration cannot be carried out through communications, where
only reading can be carried out.
（
STX
）
1HDLSP-
，
5
，
.0100 -
，
20210.
，，
2-00
Data of the sections not in use are also returned
but hyphens (2dH) enter into Load and Displacement (Time).
Space (20H)
Hyphen (2dH)
Minimum usable sections
Fixed at 1
F381A’s transmission
(In normal processing)
Maximum usable sections
Fixed at 5
Data of Section 1
，
.0202 -
，
20150.
，，
2-00
Data of Section 2
，
----0-
，
00080.
，，
1---
Data of Section 3 (last-used section)
Data of Section 4 (section not in use)
，
----0-
，
------
，，
0---
Data of Section 5 (section not in use)
Delimiter
，
----0-
，
------
，，
0---
To Next Page
Loading...
