Unipulse F381A - Work No. Selection and Work Copy; Work No. Selection; Work Copy

46
4 SETTINGS AND CALIBRATIONS
46
SETTINGS AND CALIBRATIONS
Chapter
4
11.Digital Filter
Displacements are moving-averaged by the set number of times.
Operation
Setting range (0, 2 to 999 Times)
Main screen → Setting → First Setting → X-axis Setting → Next → Next → Digital Filter
4-4. Work No. selection and work copy
■Work No. selection
Press on the Work Setting screen, and specify the work No. you want to set.
Setting range (0 to 15, All)
When each item is set with the work No. specified as “All,” the same set value enters into all of
work 0 to 15 on the set item. This function is convenient when there is any item you want to set
Operation
all work in common.
Main screen→Setting→Work Setting→Work No.
■Work copy
Work can be copied. Press on the Work Setting screen. Set
Source and Copy.
Data to be copied are all set values in Work Setting including
comparison waveforms.
Setting range
Source (0 to 15)
Operation
Copy (0 to 15)
Main screen→Setting→Work Setting→Copy