Unipulse F381A - SD Memory Card Ejection; Settings

128
7 OPTION
128
OPTION
Chapter
7
■SD memory card ejection
1.
Check that the SD memory card is not in
processing.
2. Open the SD card slot cover of the main unit.
3. Once push in the SD memory card, and then
release it.
You will hear it click, and the SD memory card will
pop out slightly.
4. Pick the SD memory card, and draw it out frontward.
5. Close the SD card slot cover.
■Settings
- Equipment ID
By setting its ID, an F381A can be controlled to differentiate from
other F381As.
* Same as the equipment ID of the Ethernet option.
Operation
Setting range (0 to 999)
Main screen→Setting→First Setting→Option Setting → SD Card→ Equipment ID
- Measurement Waveform Preservation by the
Automatic Operation
This setting is to automatically preserve the present measurement
waveform data and judgment point data on an SD memory card upon
completion of measurement.
Setting range
Off
On (Overwrite): The oldest file is erased and the present waveform is
preserved,when SD memory card is full.
On (Not Overwrite): It does not overwrite, when SD memory card is full.
Operation
* Setting “On” disables preservation and reading of set values, and formatting of an SD memory card.
Main screen→Setting→First Setting→Option Setting →SD Card→ Auto Preserv.
If "On" is set, "SD" appears under the status display on the main
screen, and upon completion of measurement, it changes to SD
Busy.
Also, in the case of an error, the corresponding error number is
displayed.
SD card
slot cover