Unipulse F381A - Result Read Command

93
5 COMMUNICATIONS
93
COMMUNICATIONS
Chapter
5
- Result read command
① Check to see if measurement is finished
If "1" is read to Waveform update, go to step ②, and if "1" is not read, repeat step ①.
(For transmitting the SAMPLE command continuously, do it at intervals of 100ms or more.)
（ STX ） Delimiter 0LSM 3APE11 518
Host
(Transmission to the F381A)
PELSAM Delimiter
F381A’s return
(In normal processing)
Undefined
Work No. used for measurement
Header (If there is no header, no data will result.)
Waveform update
0: Not made
1: Made
(If an update is made, this bit changes
from 0 to 1 only once upon reading.)
Equipment ID
* Equipment ID is a parameter.
(It can be set from the touch panel only
when the SD card slot option/Ethernet option
is mounted.)
（ STX ） Delimiter N1G
F381A’s return
(In abnormal condition)
Header (If there is no header, no data will result.)
NG No.
1: Receipt of a statement different from the command format