Unipulse F340A - 5-11. Automatic Printing

5.SETTING OF FUNCTIONS
46
5-11. Automatic Printing
The Automatic Printing function automatically prints out indicated values on a
UNIPULSE printer connected to the F340A over the SI/F. Printing is made when
indicates vales are stable. （Parameter for stabilization is set in the Motion Detect
function.） The stabilized indicated value can be held for three seconds （indicated value
hold function）.
・Operation of the indicated value hold function
Indicated
Near zero
0
Stable
Near zero
ON
ON
ON
ON
OFF
OFF
OFF
Automatic printing
↑
Hold
※ 3 seconds
Time
ON
Hold function …
Indicated value
SI/F
Output signal（HI, LOW）
value
※If the state of Near Zero ON is not keeping for three min
utes, the hold values was not canceled.