Unipulse F340A - 8-5. BCD Data Update Rate Selection

8.BCD DATA OUTPUT
62
・STROBE
BCD data is updated on a per A/D conversion and the strobe pulse synchronous with the
BCD data is output.Use the rising edge of the pulse to read data
8-5. BCD Data Update Rate Selection
BCD data
OVER
strobe range
STROBE
0
1
1) Select setting mode 4.
2) Set the update rate of BCD parallel data output.
FNC
SEL
DOWN
ENT
BCD Data Update Rate Selection
6 ： 1 times/sec. 〃 Approx. 500msec
5
： 2 times/sec. 〃 250msec
4
： 5 times/sec. 〃 100msec
3 ： 10 times/sec. 〃 50msec
2
： 20 times/sec. 〃 25msec
1 ： 50 times/sec. 〃 10msec
0 ： 100 times/sec. STROBE Range 5msec
BCD Update Rate