Unipulse F340A - 3-4. Setting Procedure

3.SETTING MODE CONFIGURATION
19
3-4. Setting Procedure
UP
DOWN
FNC
ENT
ESC
SEL
SEL
SEL SEL SEL
UP
DOWN
UP
DOWN
UP DOWN
UP
DOWN
ENT
“F2” of setting Mode2 “F3” of setting Mode3 “F4” of setting Mode4
Select a
setting item..
The most significant digit starts blinking
Select a digit where setting is desired.
Set a value.
If wishing to affix a sign to the high/low limit
and d
igital offset, D/A zero setting full scale
setting, press key.
SHIFT
CAL
Set Value is validated.
Setting Mode is terminated to return to
“F1” of setting Mode1
is displayed.
is displayed.is displayed.is displayed.
Select a
setting item..
Select a
setting item..
Select a
setting item..
to prompt setting.
the indicated value display.
If one minute has elapsed after key is pressed without any key hit
before key is pressed,the setting is canceled and the indicated value is displayed
again. The set value is not stored in this case.
FNC
ENT