2.CONNECTION
7
2. CONNECTION
2-1. Connecting to Cage Clamp Terminal Block
1.Strip the casing 0.2in (6mm) on the cable to be connected.
2.Twist the bare wire to fit the terminal hole.
3.Insert the supplied screwdriver into the upper hole and lift upward.
4.Insert the twisted wires into the lower hole.
5.Make sure cable is clamped securely and does not come out with a slight tug.
・Cable can be from 24 to 14AWG (0.2 to 2.5mm
2
)
・ It is not necessary to solder the cable wires or to fix a solderless terminal.
・If several cables to be inserted to the same hole,twist those cable wires
together and insert.
Request
To Next Page
Loading...
