WARNING
● Use F340A with correct supply voltage.
● Do not carry out the direct file of the commercial power supply to a signal input terminal.
● Carefully check wiring, etc. before applying power.
● Set the correct Excitation Voltage for the sensor. （10V is set when F340A is
dispatched from us.）
● Do not disassemble the main body for modifications or repair.
● Be sure to ground the protective ground terminal.
● When smoke, a nasty smell, or strange sound, please shut off a power supply
immediately and extract a power supply cable.
● Do not install in the following environments.
- Placeｓ containing corrosive gas or flammable gas.
- Where the product may be splashed with water, oil or chemicals.
To Next Page
Loading...
