Unipulse F340A - Page 66

6HOLD FUNCTION
57
・Timing Chart
t1 ： Time from the short-circuiting of the hold input (OFF → ON) to the display of the
hold value.
t2 ： Time from start of the hold to the A/D conversion of the hold value.
t3 ： Time from the input of the hold input (ON → OFF) to the reset of the analog hold.
t4 ： The minimum tracking (resetting) time required for resetting the display of the
held value.
Hold input
t1
t2
t4
t3
Time
t1 ： MAX 25mS
t2 ： MAX 25mS
t3 ： MAX 25mS
t4 ： MIN 25mS
Display and
BCD output
Indicated value
Sensor input