Unitech UNI-335 - Remote Start Function; Remote Start Operation

23
signal).
<4>Start engine with key, LED will fast flash when the lines are properly connected
<5>Shut down the engine when the engine speed to stabilize.
<6>when use UNI2 or remote control module will auto exit the learning mode.
<7> To re-learn the engine speed (RPM), it can learn again after Disarm the host power
and then send power.
<8> RPM can’t not learn if foot brake.
2
nd
type of method：
1.Turn the Ignition switch 'ON/OFF' 3 TIMES and stay in OFF position.
2.Push the Valet switch 11 times and hold it on the 11
th
push until five chirps &five
parking flashes then release the valet switch.
3. Press and release the transmitter
and buttons at the same time once to set the
"Tachometer Checking Type'. [1] LED flash, [1] chirp to confirm this setting.
4. Press and release the transmitter
button once, [1] LED flash, [1] chirp to indicate
your are in features "RPM Learning mode"
5. Start the vehicle with the key. (While the engine is running, the parking&LED will flash, If
don't, please check tachometer White/Red wire connection. (H6/10)
Press the valet switch, the siren will chirp one long sound then exit the learning mode.
6. Turns off the ignition switch to stop the engine running.
=============================
Remote Start Function
=============================
[Remote Start Operation]
The control module should be under the arm status then can be remote.
*press Button 4(once),can start engine by remote.
*button 4(2 seconds) to cancel engine start program; engine operation can be stopped if
running.
Engine start is fixed to 4 times:
First time: 0.8~3.0 seconds.(function setting)
Second time: automatically plus 0.2seconds.
Third time: automatically plus 0.2seconds.
Fourth time : automatically plus 0.2seconds.
* If the engine does not start successfully, the system will automatically re-start, a total
of 4 times, ignition set by function, it will plus 0.2seconds every time.
After the successful operation of the ignition detection of 7 second period, Ignition off/on
re-start interval 5seconds.(a total of 13 seconds)
* Start the engine 4 times without success, it will stop and start.
* Remote start the engine, and engine running, the security must first disarm, open car
door, Insert the key and rotate to ON,and can start the car.
*After start the engine by remote in engine running, setting arm Ignition and sensor