5
Yellow Wire 一 Ignition 1 Output
Connect the YELLOW wire to the ignition 1 wire from the ignition switch. The ignition
wire should receive “12 volts” when the ignition key is in the "ON" or "RUN" and
"START" or "CRANK" position. When the ignition is turned "OFF", the ignition wire
should receive "0" voltage. The YELLOW wire must be connected.
PINK Wire—Ignition 2 Output
Some vehicles have [2] ignition wires that must be power. Connect the PINK wire to the
ignition 2 wire from the ignition switch. The ignition wire should receive "12 volts" when
the ignition key is in the "ON" or "RUN" and “START" or "CRANK" position. When the
ignition is turned "OFF", the ignition wire should receive "0" voltage. If the PINK wire is
not used, cap the end of the wire.
Brown Wire -Accessory Output (Heater /AC Output)
Connect the BROWN wire to the accessory wire in the vehicle that powers the climate
control system.
An accessory wire will show+12 volts when the ignition switch is turned to the
"ACCESSORY" or "ON" and "RUN" positions, and will show 0 Volts when the key is
turned to the "OFF" and "START" or "CRANK" position. There will often be more than
one accessory wire in the ignition harness. The correct accessory wire will provide
power to the vehicle's climate control system. Some vehicles may have separate wires
for the blower motor and the air conditioning compressor. In such cases, it will be
necessary to add a relay to power the second accessory wire.
H5: 5 PIN WIRE HARNESS:
RED / WHITE WIRE -PARKING LIGHT RELAY INPUT
The RED/WHITE wire is the input to the flashing parking light relay. The connection of
the RED/WHITE wire will determine the output polarity of the flashing parking light relay.
If the vehicle you are working on has +12volt switched parking lights, you don't need
connect this wire. This wire is already connected to +12volt.
If the vehicle's parking lights are ground switched, cut the RED/WHITE wire, connect
the RED/WHITE wire to chassis ground.
WHITE WIRE—PARKING LIGHT RELAY OUTPUT
(+12 V 10A OUTPUT)
Connect the WHITE wire to the parking light wire coming from the headlight switch. Do
not connect the WHITE wire to the dashboard lighting dimmer switch. (Damage to the
dimmer will result). The limitation of the WHITE wire is 10 AMP max. Do not exceed this
limit or damage to the alarm and parking relay will result.
BLACK WIRE—SYSTEM GROUND—
This is the main ground connection of the alarm module. Make this connection to a solid
section of the vehicle frame.
To Next Page
Loading...
Need help?
General
