25
1. Turn the ignition ON then OFF 3 TIMES and stay in OFF position.
2. Push the Valet switch 12 times (holding in on the 12
th
push) until ten chirps then
release the valet switch. You are now in the "Return To Factory Default Setting"
programming mode.
3. Press and hold the
and buttons at the same time on the transmitter for 6 seconds,
there will be a confirmation 5 Flashes parking light to confirm the system "Alarm
Feature A, B,C,D&E Programming" all returns to factory default setting.
1，Press remote start into remote mode, if that the remote failed the LED light will flash
random times.
Engine Stop diagnostic: (The reason for failed remote start, or unusual engine stop)
LED flash 3 times, DISARM ERROR OR TRIGGER BY HOOD OR IGNITION.
LED flash 4 times, DOOR OPEN.
LED flash 5 times, HOOD OPEN.
LED flash 6 times, TRUNK OPEN.
LED flash 7 times, IGNITON ON.
LED flash 8 times, HAND BRAKE ERROR.
LED flash 9 times, NETRAL ERROR
LED flash 10 times, RPM TOO SLOW OR HIGH.
LED flash 11 times, Try 4 TIMES FAIL.
Caution!! The follow procedure must be performed after the installation of the Remote
Start Device. It is the responsibility of the installing technician to complete these tests.
Failure to test the unit in the following manner may result in personal injury, property
damage, or both.
1. Test the BRAKE shutdown circuit: With the vehicle in park (P), start the vehicle using
the remote transmitter. Once the engine is running press the brake pedal. The vehicle
should shut down immediately. If the vehicle continues to run, check the brake circuit
WHITE/ VIOLET wire (H6/17) connection.
2. Test the HOOD PIN shutdown circuit: Start the vehicle using the remote transmitter.
Once the engine is running pull the hood release and raise the noon. The vehicle
should shut down immediately. If the vehicle continues to run, check the hood pin
WHITE/ BLACK wire (H6/19) connection.
3. NEUTRAL START SAFETY TEST:
1. Set the vehicle parking brake.
2. Block the drive wheels to prevent vehicle movement
3. Sitting in the vehicle, turn the ignition switch to "ON" or "RUN" position. But do not
start the engine.
SHUTDOWN DIAGNOSTICS
TESTING YOUR INSTALLATION:
To Next Page
Loading...
Need help?
General
