Unitech UNI-335 - Test Mode; Return to Factory Default Setting

24
vibration sensor does not detect automatically.
Note:
Attention! start the engine by remote, the system must be arm status base on security.
In this test made, this system can test the Zone 2 (Instant ground trigger), the Zone 3
(Door trigger), and the Zone1&Zone 4 (2 stage shock sensor) sensitivity. The installer can
save time to test the 2-stage shock sensor sensitivity and sensor without usingthe
traditional arming/disarming procedures to test the sensors.
Enter
1. Turn the Ignition 'switch 'ON/OFF' 3 TIMES and stay in OFF position.
2. Push the Valet switch 11 times (holding in on the 11
th
) until five chirps &five parking
flashes then release the valet switch.You are now in the Start feature "E" programming
mode.
a. Test the Zone 2 / Instant Ground Trigger 8 Zone3 / Door Trigger：
Press and release the transmitter
and buttons at the same time once. [1] LED flash,
[1] siren/horn chirp to indicate your are in Zone 2/instant Around trigger and Zone 3/Door
trigger test mode.
Trigger sensor Siren chirps
Zone 2/Instant Ground trigger (H6/16 Blue wire) 2
Zone 3/Door trigger (H6/14 Green or H6/1R Violet wire) 3
b. Test the Zone 1&Zone 4 / Two Stage Shock Sensor (Connected to H9 4 Pin Plug):
Press and release the transmitter
and buttons at the same time again. [2] LED
flash, [2] siren/horn chirps to indicate you are in the shock sensor (connected to H9 4
pin plug) test mode.
1. Activate the warn-away (ffirst stage of the shock sensor / Zone 1) ,system will emit
a short chirp.
2. Activate the full alarm (second stage of the shock sensor/Zone 4), system will emit
a long chirp.
Press the
button on the transmitter. Siren chirp 1 times will confirm test mode exit.
Press the
button on the transmitter. parking light flashes 5 times will confirm exit.
TEST MODE
RETURN TO FACTORY DEFAULT SETTING: