All rights reserved 79 Service Manual e-Series (EN) 1.1.8
5.1.3 Downgrading vs. Restoring system backup
Do not downgrade the robot software to an earlier version than the version the robot was
manufactured.
Do not revert your robot software using older update packages if you have software version equal
or above 5.8 installed. If for any reason, you need to downgrade below PolyScope version 5.8, you
can do so by restoring your old system backup (system backup was implemented from Polyscope
version 5.5 ahead).
Note:The system backup requires around 4Gb memory, please use a USB stick of 4Gb or more
capacity.
To Next Page
Loading...
