Uponor Climate Control Zoning System II User Manual

22 | uponorpro.com
Unregistering all channels
When one or more channels are inaccurately registered,
it is possible to remove all registrations at the same time.
Caution: Make sure the base unit is in run mode.
Refer to the instructions below to cancel all
channel registrations.
1. Press and hold the OK button on the base unit until
the LED for channel 1 ashes red/green, or the rst
unregistered channel ashes red.
2. Press the < and > buttons simultaneously until the LEDs
for all channels except one turn off (about 10 seconds).
The one remaining ashes red.

Uponor Climate Control Zoning System II Specifications

General

Brand	Uponor
Model	Climate Control Zoning System II
Category	Thermostat
Language	English