Uponor Smatrix Base

Safety instructions
This quick start guide to serves as a reminder for
experienced installers. We strongly recommend reading
the full manual before installing the control system.
Controller
WARNING!
The Uponor system uses 50 Hz, 230 V AC
power. In case of emergency, immediately
disconnect the power.
WARNING!
Electrical installation and service behind
secured 230 V AC covers must be carried
out under the supervision of a qualifi ed
electrician.
WARNING!
The transformer module is heavy and might
detach if the controller is held upside down
without the cover on.
CAUTION!
To avoid interference, keep installation/data
cables away from power cables of more than
50 V.
CAUTION!
Ensure that each actuator is connected to the
correct channel so that the thermostats are
controlling the correct loops.
NOTE!
Wires between transformer and controller card
needs to be disconnected prior to detaching.
NOTE!
Connect only one actuator for each channel.
Channels 01 and 02 have double outputs (a
and b) for two actuators.
Thermostat/System device
NOTE!
Registration of at least one thermostat must
be done before registering a system device.
CAUTION!
The switches in the public thermostat must
be set before the thermostat is registered.
CAUTION!
The switches, in the public thermostat, must
be set to one of the available functions,
otherwise it cannot be registered.
QUICK GUIDE
5
UPONOR SMATRIX BASE · QUICK GUIDE
UK
CZ
DE
DK
EE
ES
FI
FR
HR
HU
IT
LT
LV
NL
NO
PL
PT
RO
RU
SE
SI
SK