uponor.com l 5
Chapter 2:
Safety Instructions
This installation and operation manual describes how to
install and properly setup the components of the Uponor
Smatrix Pulse system.
Refer to the following important safety instructions before,
during, and after installation of the Smatrix Pulse system.
Symbols
The following symbols are used in Uponor documentation
to show special precautions when installing and operating
any Uponor equipment.
Warning!
Risk of injury or component damage. Ignoring
warnings can cause personal injury or damage to
system components.
Caution!
Risk of equipment malfunction. Ignoring cautions
can cause system malfunctions.
Note
Important information to the section in the
manual.
Safety Measures
Conform to the following measures when installing and
operating any Uponor equipment.
• Read and follow the instructions in the installation and
operation manual.
• Installation must be performed by a trained, licensed,
and experienced professional in accordance with local
regulations.
• It is prohibited to make changes or modifications not
specified in this manual.
• All power supplies must be switched off before starting
any wiring work.
• Do not use water to clean Uponor components.
• Do not expose the Uponor components to flammable
vapors or gases.
Uponor cannot accept any responsibility for damage
or breakdown that can result from ignoring these
instructions.
Power
Warning!
The Uponor system uses 115V 60 Hz AC power. In
case of emergency, immediately disconnect the
power.
Technical Constraints
Caution!
To avoid interference, keep installation/data
cables away from power cables of more than 50V.
Limitations for Radio Transmissions
Wireless Uponor products use radio transmission for
communication. The frequency used is reserved for similar
applications, and the chances of interference from other
radio sources are very low.
However, in some rare cases, it might not be possible to
establish perfect radio communication. The transmission
range is sufficient for most applications, but each
building has different construction that may affect radio
communication and maximum transmission distance.
If communication difficulties exist, Uponor recommends
relocating the antenna to a more optimal position and
installing Uponor radio sources at least 16" (41 cm) apart
for solving communication problems.
Disposal
At the end of its working life, do not dispose of any Smatrix
Pulse components with other household waste. To prevent
possible harm to the environment or human health
from uncontrolled waste disposal, please separate this
from other types of wastes and recycle it responsibly to
promote the sustainable reuse of material resources. For
proper disposal information, contact local recyclers for
environmentally safe recycling.
To Next Page
Loading...
