Uponor SYSTEMpro 311

SYSTEMpro 311 Program Setup
102
APPENDIX V
APPENDIX V - SYSTEMpro 311 Program Setup
MISC. MENU
UNIT (°F or °C) _____°F _____°C
BACKLITE _____OFF _____90 sec _____ON
ACCESS Level _____ADV _____INST _____USER _____LTD
BOILER / HIGH TEMP ZONES SETTINGS
Boil ROOM (desired room temp for high temp zones) _____°F
Boil INDR (room temp for high temp zones used in heat-loss) _____°F
Boil DSGN (design supply temp from heat-loss/design of bldg.) _____°F
DHW SETTINGS
DHW THRU (select DHW device) _____NONE _____PUMP _____VALV
DHW SENS (select whether a sensor is used) _____NONE _____DHW
DHW TANK (set tank temp or OFF) _____OFF _____°F
DHW PRI (select MIX if you want priority over heating) _____NONE _____MIX
MIXING DEVICE SETTINGS
MIX ROOM (room temp for Mixing zones) _____°F
MIX 10K (select 10K sensor) _____NONE _____INDR _____ZOIN _____SLAB
SLAB MIN (set slab minimum temp or OFF) _____OFF _____°F
SLAB MAX (set maximum slab temp) _____°F
MIX MIN (lowest temp the control to use or OFF) _____OFF _____°F
MIX INDR (set to the room temp from heat-loss) _____°F
MIX DSGN (design supply water temp from heat-loss/design) _____°F
MIX MAX (highest supply water temp allowed) _____°F
OUT DSGN (outdoor design temp from heat-loss) _____°F
MIXING (floating action or variable speed injection) _____FLOT _____VAR
MOTR SPD (motor speed for actuator motor) _____sec