EasyManuals Logo

Upright NX15 User Manual

Upright NX15
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
Page 10 113100-020 - MX15 / MX19 - Operation Manual
Operation
L
OWERING
THE
P
LATFORM
1. Turn the Lift/Drive Switch to .
2. Check around the base of the platform to ensure that no one is in contact with the machine. Engage the
Interlock Switch and pull back on the Control Handle to lower the platform.
3. The platform will stop when it reaches the PPE cutout height. Inspect around the machine to ensure no
one is in contact with the machine. After a four-second time delay, lower the platform as in step 2.
E
MERGENCY
L
OWERING
WARNING
!
!
If the platform should fail to lower, NEVER climb down the elevating assembly.
Stand clear of the elevating assembly while operating the Emergency Lowering Valve Knob.
Figure 4:
Emergency Lowering
The Emergency Lowering Valve Knob is located
beside the ladder at the rear of the machine.
1. Open the Emergency Lowering Valve by pulling
and holding the knob.
2. To close, release the knob. The platform will not
elevate if the Emergency Lowering Valve is open.
Emergency
Lowering
Valve Knob

Table of Contents

Other manuals for Upright NX15

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Upright NX15 and is the answer not in the manual?

Upright NX15 Specifications

General IconGeneral
BrandUpright
ModelNX15
CategoryLifting Systems
LanguageEnglish

Related product manuals