Page 8 113100-020 - MX15 / MX19 - Operation Manual
Operation
O
PERATION
Before operating the work platform, ensure that the Pre-Operation Safety Inspection has been completed
and that any deficiencies have been corrected. Never operate a damaged or malfunctioning machine.
The operator must be thoroughly trained on this machine.
P
LATFORM
E
XTENSION
Figure 3:
Platform Extension
1. Mount the platform and properly close the entrance.
2. Depress the foot lever located at the rear of the plat-
form extension. Push the platform extension forward
until the pin engages the front stop.
3. To retract the platform extension, depress the foot
lever and pull the platform extension toward the rear
of the machine until the pin engages the rear stop.
T
RAVEL
W
ITH
THE
P
LATFORM
L
OWERED
1. Check that the route is clear of surface hazards
such as holes, drop-offs, bumps, or debris.
2. Check that the route is level, and is capable of sup-
porting the wheel loads.
3. Verify that the Chassis Key Switch is turned to
and the Chassis Emergency Stop Switch is
ON (pulled out).
4. Mount the platform and properly close and secure the entrance.
5. Check clearances above, below, and to the sides of machine.
6. Pull the Platform Emergency Stop Switch out to the ON position.
7. Turn the Lift/Drive Switch to .
8. Engage the Interlock Switch and move the Control Handle to or to travel in the desired direc-
tion. The speed of the machine will vary depending on how far from center the Control Handle is moved.
2
1
1. Platform Extension
2. Foot Lever (deck lock assembly)
FORWARD
REVERSE
To Next Page
Loading...
Need help?
General
