System Function Inspection
113100-020 - MX15 / MX19 - Operation Manual Page 7
16. Turn the Chassis Key Switch to .
17. Check that the route is clear of surface hazards such as holes, drop-offs, bumps, curbs, or debris, and is
level and capable of supporting the wheel loads.
18. Mount the platform and properly close and secure the entrance.
19. Turn the Lift/Drive Switch to .
20. Check for speed and directional control.
• While engaging the Interlock Switch, slowly position the Control Handle to then . The farther
you push or pull the Control Handle from center the faster the machine will travel.
21. Push the Steering Switch RIGHT, then LEFT, to check for steering control.
22. Check clearances above, below, and to the sides of machine.
23. Turn the Lift/Drive Switch to to check platform lift controls.
• While engaging the Interlock Switch, move the Control Handle to to raise the platform.
• While engaging the Interlock Switch, move the Control Handle to to lower the platform. The
platform should descend and the audible lowering alarm should sound.
24. Push the Platform Emergency Stop Switch to check for proper operation. All machine functions should
be disabled. Pull out the Platform Emergency Stop Switch to resume.
FORWARD
REVERSE
To Next Page
Loading...
Need help?
General
