1-2
1. Introduction
P
LATFORM
C
ONTROLLER
The platform controller contains the controls to operate the machine. It is located at
the front of the platform cage. A complete explanation of control functions can be
found in Section 2.
E
LEVATING
A
SSEMBLY
The platform is raised and lowered by the elevating assembly. The hydraulic pump,
driven by the engine, powers the cylinders. Solenoid operated valves control raising
and lowering.
C
HASSIS
The chassis is a structural frame that supports all the components of the SL26/30SL
work platform.
P
URPOSE
OF
E
QUIPMENT
The objective of the work platform is to provide a quickly deployable, self-propelled,
variable height work platform to elevate personnel and materials to overhead work
areas.
S
PECIAL
L
IMITATIONS
Travel with the platform raised is limited to a creep speed range.
Elevating of the work platform is limited to firm, level surfaces only. Any degree of
slope greater than 2° will sound a warning alarm when the machine is elevated.
DANGE
R
! !
The elevating function shall ONLY be used when the work platform is
level and on a firm surface.
The work platform is NOT intended to be driven over uneven, rough,
or soft terrain when elevated.
To Next Page
Loading...
