Intended use
01/21 FlowTimer+ Set 10
3.2 Main differences from PPC 3000 Basic
The FlowTimer+ no longer shuts off if the system is not tight
(observed over hours), but only displays this for convenience!
The shut-off valve of the FlowTimer+ is open without power! Thus,
the water supply can be comfortably restored only by switching off
the power supply if required or during a power failure. An active
bypass mode is therefore no longer included.
The FlowTimer+ can also be installed upstream of the filter or
backwash filter because of an integrated filter system.
A configuration of the system is no longer necessary in most
applications, which means that the system is immediately ready for
operation after proper installation!
The maximum permanent flow duration and sensitivity can be
adjusted to personal needs very easily at the touch of a button.
A test mode is also available to assist the customer or installer in
troubleshooting a possible leak.
To Next Page
Loading...
Need help?
General