UseTECH FlowTimer+ - 9 Operation and Function; Operating States; Normal Operation; Restarting the System

Operation and function
01/21 FlowTimer+ Set 29
9 Operation and function
9.1 Operating states
9.1.1 Normal operation

FlowTimer+ works permanently, automatically in normal
operation and disconnects the consumer from the
supplier by means of a solenoid diaphragm valve in the
event of a fault.
The FlowTimer+ operating status can be seen via the device
illuminated rim (9) (see chapter Fehler! Verweisquelle konnte
nicht gefunden werden."Fehler! Verweisquelle konnte nicht
gefunden werden.") and the flow duration display (10).
Should the FlowTimer+ interrupt the water supply during normal
operation, fault identification is possible via the status display.
9.1.2 Restarting the system
 Briefly press the Set / Reset key (8).
or
 Unplug the power supply unit (1) from the socket or disconnect
the power supply.
 wait ten seconds
 Restore voltage supply