Troubleshooting, maintenance
01/21 FlowTimer+ Set 38
Check mains pressure
Check the plug connection of sensor plug and pressure sensor
Do not remove the pressure sensor under any
circumstances. Sensor is located directly in the pressure
range of the water. Water with high pressure could escape.
Check if water has been used for a long period without
interruption.
If a longer permanent flow duration is required, the system can be
specifically adapted to your application (please refer to chapter
9.1.5 "Changing the flow duration").
If no prolonged water withdrawal is known, the piping system must
be tested for tightness (see chapter 8.2 "Checking the tightness").
To Next Page
Loading...