Convert Server User Manual www.usriot.com
Jinan USR IOT Technology Limited 25 / 44 tec@usr.cn
5.6.5. Multiple STA parameters
This function based on V5.01D.01 and above version of the firmware, in the sta mode, if can network signal is
too low, it will automatically switch to the other AP network (switching network automatically restart).
This feature provides a signal threshold, when the current network signals is lower than the critical value, the
Convert Server of automatic switching network and restart.If the signal value is set to 100, the Convert Server
will not switch network.Even if the current network signal is not the current network will always search, not
heavy to other networks.
The function of the specific Settings page refer to section 5.3.3.
This Convert Server can realize the function of the websocket server, allowing serial real-time interaction with
the web Convert Server, replace the previous HTTP GET, POST, corresponding faster.This Convert Server
provides the corresponding websocket test page for user testing, specific page is as follows:(web
Page:10.10.100.254/websocketen.html)
Click on the "connect" page and then implements a connection, so a serial port with page can send or receive
data from each other.This Convert Server websocket server support 8 client connection at the same time.
This function for web applications, and for web users with higher response speed, if you want to customize
the corresponding web page, can connect your company.
Base on selected factory default setting, “Ready” signal can have two output statuses:
Status One: The Convert Server will output “ 0” after normal boot up. This signal used to judge if
To Next Page
Loading...
Need help?
General
