USR IOT USR-WIFI232-630 - Q5: Two Servers STA Connection via AP

Convert Server User Manual www.usriot.com
Jinan USR IOT Technology Limited 38 / 44 tec@usr.cn
Figure 32 Convert Server Network Protocol: TCP/Client

Protocol: UDP

No Server/Client selection required;

Application IP address required: it’s target device ‘s IP address;

Port ID required: 8899 (Default)
Figure 33 Convert Server Network Protocol: UDP
Q5: How to configure transparent serial port application: Two Convert
Servers all configured as STA and connection through AP?
 Network structure as below figure:
 Convert Server 1# Setting: ( We use USR-WIFI232-D2 as AP for this example)
 Works as AP mode and all default setting;
 Convert Server 2# Setting:
 Works as STA mode; --See “Mode Selection Page”
 WAN connection type: Static IP: 10.10.100.100; --See “STA Interface Setting Page”
 Network Protocal:TCP/Server, Port ID: 8899; -- See “Application Setting Page”
 LAN IP address: 10.10.99.254 (Different net segment with WAN port);
--See “AP Interface Setting Page”
 Convert Server 3# Setting:
 Works as STA mode; --See “Mode Selection Page”
 WAN connection type: Static IP: 10.10.100.101; --See “STA Interface Setting Page”
 Network Protocal:TCP/Client, Port ID: 8899; Application IP address: Convert Server 2#’s WAN IP
address (10.10.100.100); -- See “Application Setting Page”