USR IOT USR-WIFI232-630 - Q4: Convert Server Network Protocol Settings

Convert Server User Manual www.usriot.com
Jinan USR IOT Technology Limited 37 / 44 tec@usr.cn
Interface Setting Page”
 Network Protocal:UDP, Port ID: 8899; Application IP address: Convert Server 1#’s LAN IP address
(10.10.100.254); -- See “Application Setting Page”

LAN IP address: 10.10.99.254 (Different net segment with WAN port)
--See “AP Interface Setting Page”
Figure 30 Configure Transparent Serial Port Connection (UDP)
Q4: Where to set Convert Server network protocol (TCP/UDP)?
 USR-WIFI232-D2 network protocol setting see “Application Setting Page” as below Figure,
 Protocol: TCP Server
 Only Port ID required: 8899 (Default)
Figure 31 Convert Server Network Protocols: TCP/Server
 Protocol: TCP Client
 Application IP address required: it’s target TCP server ‘s IP address;
 Port ID required: 8899 (Default)