10-13
Troubleshooting > Responding to Messages
Responding to Messages
If the touch panel or the computer displays any of these messages, follow the corresponding procedure.
A
B
Message Checkpoints Corrective Actions Reference
Page
Acceptable staple count
exceeded.*
* When Auto Error Clear is set to [On], processing resumes automatically after a set amount of time elapses.
Is the acceptable staple count
exceeded? For details, refer to
Document Finisher (option) on
page 11-22.
Press [Continue] to print without
stapling.
Press [Cancel] to cancel the job.
—
Activation error. — Turn the main power switch off and on. If
the error exists, contact administrator.
2-12
Add the following paper in
cassette #.
Is the indicated cassette out of
paper?
Load paper.
Press [Paper Selection] to select the
other paper source.
Press [Continue] to print on the paper in
the currently selected paper source.
3-3
Add the following paper in the
multi purpose tray.
Is the paper of the selected size
loaded in the multi purpose tray?
Load paper.
Press [Paper Selection] to select the
other paper source.
Press [Continue] to print on the paper in
the currently selected paper source.
3-5
Does the paper size set for the
paper source matches the paper
size that was actually loaded?
Press [Continue] to continue printing.
Press [Cancel] to cancel the job.
—
Adjusting Scanner. — The machine is under the adjustment to
maintain its quality. Please wait.
—
Message Checkpoints Corrective Actions Reference
Page
Box limit exceeded.*
* When Auto Error Clear is set to [On], processing resumes automatically after a set amount of time elapses.
Is [End] displayed on the touch
panel?
Document box is full, and no further
storage is available; Job is canceled.
Press [End]. Try to perform the job again
after printing or deleting data from the
Document Box.
—
To Next Page
Loading...
Need help?
General
