Maintenance
5-7
6
Place the old toner container in the plastic bag provided
for disposal.
7
While holding the charger cleaner rod, gently pull it out
as far as it will go and push it in again.
Repeat this operation two or three times.
Note Do not use excessive force to pull the rod or attempt to pull it out completely.
8
While pushing the electrical charge section to the right,
pull it out approximately 5 cm (2 inches).
Remove the accompanying grid cleaner from its
package and remove its cap.
Fit the grid cleaner to the notch and install it into the
main body.
9
While holding gently the grid cleaner with your left
hand, pull out the electrical charge section as far as it
will go and push it back until the portion B does not
touch the white pad of the grid cleaner.
Repeat this operation several times.
Important! When pushing back the electrical charge section, do not push it all the way into the main body.
Copying trouble may occur.
B
To Next Page
Loading...
Need help?
General
