Vacon 100 - FBFIXEDSTATUSWORD

6
vacon • 62 Communications
Tel. +358 (0) 201 2121 • Fax +358 (0)201 212 205
6.3.4.2 Ready Indication bit in Vacon FBFixedStatusWord
The “Ready Indication” bit 0 in the Vacon FBFixedStatusWord is mapped to the “Ready” bit in an In-
put Assembly which supports this bit.
6.3.4.3 Run/Stop Indication bit in Vacon FBFixedStatusWord
The “Run/Stop Indication” bit 1 in the Vacon FBFixedStatusWord is mapped to the “Running1” and
“Running2” bits in an Input Assembly which supports these bits.
The state of the Running1 and Running2 bits depends further on the “Direction Indication” bit 2 of
the Vacon FBFixedStatusWord as follows:
6.3.4.4 Direction Indication bit in Vacon FBFixedStatusWord
See chapter 6.3.4.3.
6.3.4.5 Fault Indication bit in Vacon FBFixedStatusWord
The “Fault Indication” bit 3 in the Vacon FBFixedStatusWord is mapped to the “Faulted” bit in an
Input Assembly which supports this bit.
6.3.4.6 Alarm Indication bit in Vacon FBFixedStatusWord
The “Alarm Indication” bit 4 in the Vacon FBFixedStatusWord is mapped to the “Warning” bit in an
Input Assembly which supports this bit.
2 Running clockwise Running counter-clockwise
3 No fault Fault active
4 No alarm Alarm active
5 Not reached reference Reference reached
6 Motor not running zero
speed
Motor running at zero
speed
7 Motor not magnetized Motor magnetized
8-12 Reserved Reserved
13-15 Application-Specific Application-Specific
Table 59.
Run/Stop = 0 Run/Stop = 1
Direction = X Direction = 0 Direction = 1
Running1
010
Running2
001
Table 58.