Vacon NX Service Manual

Fault codes and software
24h on-call service phone: +358 (0)40 83 71 150
56
4
FIGURE 15. Fault code F13
Read operation temperature of
the unit from monitoring page.
F13 Undertemperature fault
Did value correspond to
ambient temperature
and temperature lower
than -10 C.
NO
YES
F13 displayed.
Check logged
data in
fault history.
External fault: Temperature is
too low.
Internal fault: Check the
temperature measurment
circuit.
NOTE!
FR9: Power board has its own
temperature measurement, which
can activate F13.

Vacon NX Specifications

General

Product Type	AC Drive
Control Method	Scalar Control
Enclosure	IP00, IP21
Communication	Ethernet
Safety	STO (Safe Torque Off)
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overtemperature, Short Circuit
Ambient Temperature Range	-10°C to +50°C (with derating above +40°C)
Cooling Method	Air-cooled, Liquid-cooled