After market service information
24h on-call service phone: +358 (0)40 83 71 150
10
2
Note: Information about older drives may not be present in some appendix manuals.
8.4. Important instructions for various service situations
Review each procedure and section in advance. This chapter and its subchapters con-
tains important information, which must be applied in service situations.
• Local and national laws and regulations, concerning the service work to be per-
formed, must be followed.
• Vacon Plc. cannot be held responsible for personal injuries or material damage,
which may occur when local or national laws concerning service work have not been
followed.
• All plastic covers must be reinstalled on AC Drives before switching on the power
supply.
8.4.1. Personal requirements
Personnel performing service work must have qualifications that are in accordance with
the local and national laws.
WARNING! O
NLY
QUAKIFIED
SERVICE
TRAINED
PERSONNEL
ARE
ALLOWED
TO
USE
THIS
MATERIAL
AND
PERFORM
ANY
OF
THE
SERVICE
ACTIONS
MENTIONED
. T
HE
PERSONNEL
PRE
-
FORMING
LOCAL
SERVICE
WORK
ON
THE
DRIVES
MUST
HAVE
QUALIFICATIONS
THAT
ARE
IN
ACCORDANCE
WITH
THEIR
NATIONAL
LAW
.
8.4.2. Personal safety notice
Mechanical surfaces, which display a warning 'hot surface' sticker, must not be
touched. Make sure the working environment is safe, and there is nothing that will
cause any risk of personal injury.
WARNING! A
DRIVE
THAT
IS
TO
BE
REPAIRED
MUST
NOT
BE
POWERED
UP
DURING
SERVICE
WORK
,
UNLESS
IT
IS
SPECIALLY
MENTIONED
TO
DO
SO
IN
THE
SERVICE
INSTRUCTIONS
.
TABLE 5.
Chapter information in the appendix manuals.
Chapter Information
Updates in manual Short description about added or updated material.
Main circuit diagrams Contains different versions of the main circuit diagram.
Exploded view 3D-model(s) showing the spare part numbers
Measurement instruc-
tions
Instruction on how and where to measure different parts
and circuits.
Replacement instruc-
tions
Instruction on how to remove and replace different parts
or subassemblies.
Specifications Other instructions such as how to modify mass custom-
ized boards and torque lists.
To Next Page
Loading...
Need help?
General
