Chapter 3 _______________________________________________________________ Installation
VAISALA_______________________________________________________________________ 23
Mounting the Transmitter Housing
1. Attach the mounting plate to the wall with 4 screws.
2. Press down the transmitter so that it slides along the rails of the
mounting plate.
3. Fasten the transmitter to the mounting plate with the Allen screw
(3 mm Allen key provided).
The probe can be detached and replaced when needed by simply
unfastening the two Allen screws.
0603-037
Figure 6 Transmitter Mounting
The following numbers refer to Figure 6 on page 23:
1 = Mounting plate
2 = Transmitter housing
3 = Allen screw
4 = Allen screws
To Next Page
Loading...
