Autocalibration page shows current status of autocalibration and a history of autocalibration
events. Admin user can configure the automatically started autocalibration on this page and
also start a manual autocalibration cycle.
Figure 21 Autocalibration page
3.1.7 Service pages
Service pages provide tools for servicing the DGA monitor, troubleshooting problems, and
recovering from error states:
• Diagnostics package tool generates a diagnostic file package for use by Vaisala. The
package can be used by Vaisala support to diagnose any issues you may have with the
DGA monitor.
• Bleeding tool is used to bleed excess gas out of the DGA monitor. Running this tool is
only necessary if a device alert indicates the presence of excess gas in the system.
• Configuration package tool is used for installing a customized configuration package that
has been sent by Vaisala.
Chapter 3 – User interface
43
To Next Page
Loading...