3.3 Starting measurement
In normal operation DGA monitor repeats the measurement cycle continuously. You can only
start the measurement if DGA monitor is currently in standby.
1. Connect to the DGA monitor user interface and log in as an Admin user.
2. Start measurement from Control > Start Measuring.
DGA monitor warms up during the first three measurement cycles. Measurements
made during the warm-up cycles are not guaranteed to be within the accuracy
specification.
3.4 Setting device name
Figure 26 General settings page
You can give a name to the DGA monitor to help identify it. If the name is set, it is shown in:
• Login page
• Above the Optimus text in the navigation menu
• Names of files downloaded from the user interface
1. Connect to the user interface as the Admin user.
2. In the user interface, select Settings > General.
OPT100 User Guide M211858EN-U
48
To Next Page
Loading...